While I cannot host the file directly, you can find the verified original dump and loader tools at these reputable sources: STARSAT Official Support Site

Flashing a dump file incorrectly can permanently damage your receiver. Always verify that the file's board ID matches your specific hardware before proceeding.

Load the .bin or .rar (extracted) file into the programmer software. Erase the chip, then write the new dump file. :

: Sites like Tunisia-Sat or Sat-Universe

Select the correct COM port and file, then power on the receiver to start the flash process. File Specifications : STARSAT SR-2030 HD (Mini/Normal versions vary, check your board ID). File Extension : Usually .bin inside a .rar archive.

Using a "dump" file usually requires hardware tools because the receiver won't boot normally. :